#Diy homemade bud trimmer how to
#Diy homemade bud trimmer full

But, at first, you’ll want to attend to your machine to make sure you’re getting good results and have the right run time dialed in. Your operator won’t need a lot of involvement and can generally turn their attention to other tasks while the machine runs. Triminator Dry machines are designed to run autonomously. Try trimming your lower and mid buds first. Start with the less desirable parts of your harvest and work your way up - literally - to the better flowers. Material that’s headed to extraction makes a better guinea pig than your top flowers. Don’t put all your eggs in one basket, and start with small tasks for your dry trimmer.Īlso, don’t begin your learning curve with your best material. This method of trialing a new technology is the same everywhere - whether you’re rolling out LED lights or a new irrigation system.

#Diy homemade bud trimmer full

Your first run won’t be your best, but if you follow these suggestions, you’ll be churning out prize-quality product within a few runs.Ī large harvest isn’t the time to implement new technology at full scale.

If you’re new to dry trimmers, expect a learning curve.

#Diy homemade bud trimmer how to

How to Start Dry Trimming Cannabis and Hemp Flower But expect more moisture loss in the first two days after your harvest - about 2-3% per day. Look for a 1% moisture drop per day, and use your moisture meter to check. If you can stretch your drying time to three weeks, that’s better than two. Slower is always better when drying your cannabis and hemp flower. Levels as high as 60% are acceptable if the temperature climbs into the 70s. But if it’s too hot to maintain 60℉, raise the humidity to slow the drying process. Shoot for 40% humidity at 60℉ for best results. To reach the 9-10% level, your harvest needs to dry for two weeks at the right temperature and humidity conditions. The answer to a malfunctioning dry trimmer lies in your drying room (and/or the amount of time your product dried before trim day). And it’ll need cleaning much sooner than you’d expect because the sticky wet material will buildup on the cutting surface. Your machine will struggle to give a close trim. Dry trimmers run into trouble when loaded with wet or not-dry-enough material.